Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
Configuring the System 4-19
Configuring Hub Parameters
Select Hub Configuration under the System Configuration
menu to configure any hub in the stack. This menu is used to
configure the hub and SNMP agent. Use the following menu to
select the required hub, or to change the numeric identifier for
any hub in stack.
HP J3233A AdvanceStack 100Base-T Hub-12TXM
Hub Configuration
-----------------------------------------
Back to Previous Menu
Hub 1 Configuration ...
Hub 2 Configuration ...
Hub 3 Configuration ...
Hub 4 Configuration ...
Hub 5 Configuration ...
Hub ID Configuration ...
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.11 Hub Configuration: Hub Selection Menu