Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
4-22 Configuring the System
Configuring Port Parameters
Select Port Configuration under the System Configuration
menu to configure the ports for any hub in the stack. Select the
port type for the required hub from the following menu.
HP J3233A AdvanceStack 100Base-T Hub-12TXM
Port Configuration
-----------------------------
Back to Previous Menu
Hub ID | Port ID
--------+------------------------
1 | 1 - 12 Exp Slot
2 | 1 - 12 Exp Slot
3 | 1 - 12 Exp Slot
4 | 1 - 12 Exp Slot
5 | 1 - 12 Exp Slot
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.14 Port Configuration: Port Selection Menu
Configuring Hub Ports
If you select the hub port type (i.e., 1 through 12), the Port
Configuration Menu will open. This menu displays the ID and
stack position of the selected hub, and also allows you to
enable/disable any hub port in the selected hub.