Release Notes K.12.26

62
Enhancements
“OSPF Passive and Routing Interface Increase”
To display the OSPF information, enter the command shown in Figure 6:
Figure 6. Example of the show ip ospf interface Command with Passive Configured on an Interface
You can display the OSPF information for a particular VLAN, as shown in Figure 7.
Figure 7. Example of the show ip ospf interface Command for a specific VLAN with Passive Configured on
an Interface
Syntax: [no] ip ospf <ip-addr> passive
Configures passive OSPF for an Autonomous System.
The no option disables the passive option; the interface becomes an active interface.
Default: Active
<ip-addr>: Optionally you can configure an IP address on the VLAN
ProCurve(vlan-1)# show ip ospf interface
OSPF Interface Status
IP Address Status Area ID State Auth-type Cost Priority Passive
---------- ------ ------- ----- --------- ---- -------- -------
10.10.10.1 enabled 0.0.0.2 down none 1 1 Yes
10.12.13.1 enabled 0.0.0.2 wait none 1 1 No
ProCurve(config) show ip ospf interface vlan 4
OSPF configuration and statistics for VLAN 4
OSPF Interface Status for 10.10.10.1
IP Address: : 10.10.10.1 Status : enabled
AreaID : 0.0.0.2 Passive : Yes
State : DOWN Auth-type : none
Cost : 1 Chain :
Type : BCAST Priority : 1
Transit Delay : 1 Retrans Interval : 5
Hello Interval : 10 Rtr Dead Interval : 40
Designated Router: Events : 0
Backup Desig. Rtr: Passive : yes