xl Modules Installation Guide 2007-12

ProCurve Switch xl Modules

Installing the Modules

Status LEDs

There are two status LEDs:

■ PoE - lights when PoE power is being supplied to one or more PDs. It goes

out when there are no valid loads attached to any of the ports. It will blink

to indicate an error on any of the ports or when any port is denied PoE

power.

■ EPS - lights when the module is connected to a 600 RPS/EPS or a 610 EPS.

It goes out when the 600 RPS/EPS or 610 EPS is disconnected from the

module. It blinks when there is an error on the 600 RPS/EPS or 610 EPS

or it is over-subscribed, more PoE power is needed than the 600 RPS/EPS

or 610 EPS can supply.

LED Mode LEDs

The Std or PoE LED lights depending on which mode has been selected by

pressing the LED Mode button.

If the Std LED lights, the Link and Mode Port LEDs display information as

listed in the previous table.

If the PoE Mode LED lights:

■ The Link LED is on, indicating there is a valid 10base-T or 100base-TX

connection.

■ The Mode LED is on, indicating that the port is providing PoE power.

■ The Mode LED is off, indication that the port is not providing PoE power.