xl Modules Installation Guide 2007-12

25
ProCurve Switch xl Modules
Installing the Modules
Connecting the 10-GbE Network cables
Connecting a fiber cable.
1. Remove the dust covers from
the cable connectors and the
port.
2. Aligning the notches on the
cable connectors with the slots
of the port, press the cable
connector into the port until it
snaps into place.
If the Link LED does not go on
when the network cable is
connected to the port, see the
Troubleshooting section on
page 31.
To disconnect:
Grasp the plastic pull tab and pull the cable connector straight out. This
disengages the locking mechanism.
Connecting a copper cable.
1. Push the copper cable
connector into the copper port.
Ensure the locking device locks
the cable connector into place.
To disconnect:
Grasp the plastic pull tab and pull
the cable connector straight out.
This disengages the locking
mechanism.
2
Figure 17. Connecting a fiber cable
Figure 18. Connecting a copper
cable