Release Notes G.07. 53

Software Fixes

Release G.07.50 11/11/03

 Routing (PR_1000003867) — ICMP Redirect entries don’t age (from the route table).

When the route table fills we cannot add new routes. Note: users are likely unaware that we

store ICMP Redirect entries in the route table.

 RSTP (PR_1000001612) — Under some circumstances a port may take approximately 30

seconds to go into Forwarding state.

 sysUptime (PR_10000004025) — sysUpTime rolls over (to zero) after approximately 49

days. With this fix it now correctly rolls over after about 1.6 years (2^32 times 1 cSecond).

 Web (PR_81848) — The 'Clear changes' button does not work for the Default Gateway or

VLAN selections.

 Web (PR_82039) — If the user selects GVRP mode, selects a port, and then selects nothing

as an option for the port mode all ports below the selected port disappear. This does not

affect the switch's configuration. It is a cosmetic defect.

 Web (PR_82199) — VLAN port modification shows misleading mode. In the Configuration

- VLANs - Modify page, sele

ct a port, then set the "mode" modify pull-down menu to "tagged".

Select another port. The "mode" pulldown field remains set to "tagged" which is misleading

and incorrect, in general.

 Web (PR_92078) —After making changes under the Device Features tab the resulting page

never fully loads.

 Web (PR_97407) — When the user tries to add a MAC address that is already a MAC lockout

address (as an authorized address) the switch responds with the incorrect message, Unable

to add new MAC Address. MAC entry is either a multicast, broadcast

or NULL address.

 Web (PR_1000000452) — Resetting the switch leads to the URL aol.co.uk

 Web: (PR_1000001702) — Sometimes when the user clicks on the Apply button on the

Configuration/Monitor Port screen the switch complains, not enough params specified.

 Web/GVRP (PR_1000003124) — When GVRP is enabled and the user tries to add a new

VLAN using the Web UI, the error message is the vague Commit failed. With G.07.51 this

error message is now Maximum number of VLANs (max-vlans) has already been

reached. Secondly, also in the Web UI, the switch gives the vague error message, An error

was encountered while attempting to add the VLAN entry. In G.07.51 the

switch reports that the maximum number of VLANs has already been reached.

Release G.07.50 11/11/03

The version number for this release was increased to represent the new support for the 10/100/

1000Base-TX module (J4908A).