Release Notes G.07. 53

Software Fixes

Release G.05.01

 Never released.

 Adds support for the ProCurve Switch 4104GL.

 Adds support for the J4893A ProCurve Switch GL mini-GBIC module.

 Time Zone Issue: Starting with the G.05.xx version of the switch operating system software,

the method of configuring the Time Zone for TimeP or SNTP configuration has been updated.

Previous switch software, for all HP ProCurve switches, used positive time offset values for

time zones that are West of GMT and negative values for time zones that are East of GMT.

The standards indicate that time zones West of GMT should be designated by negative offset

values, and time zones East of GMT by positive values. Software version G.05.xx updates

this configuration method, but if you use the same values for indicating time zones as you

did for previous HP ProCurve switches, the time will be set incorrectly on your Series 4100GL

Switch. For example, for previous HP ProCurve switches, the US Pacific time zone was

configured by entering +480. With software version G.05.xx, the US Pacific time zone must

now be configured by entering -480.

 Agent Hang (PR_4381) — Agent processes (such as console, telnet, STP, ping, etc.) may

stop functioning when the IGMP querier function is disabled, and then re-enabled, on a VLAN

that does not have an IP address configured.

 Agent Hang (PR_4562) — Agent processes (such as console, telnet, STP, ping, etc.) may

stop functioning. This agent hang has been associated with the CERT SNMPv1 “encoding”

test #1150.

 Agent Hang (PR_4805) — Agent processes (such as console, telnet, STP, ping, etc.) may

stop functioning. This agent hang has been associated with the X2 SSH utility.

 CLI (PR_3786) — The CLI command “show arp” displays the wrong port number for some

ARP entries.

 CLI (PR_3792) — The CLI command “show trunks” lists incorrect information for dynamic

trunks.

 CLI (PR_3809) — The CLI command “getmib” with no parameters returns the message

“Incomplete input: - EOI -”.

 CLI (PR_3895) — Unrelated information was shown at the end of the CLI command “show

vlan 1” output.

 CLI (PR_3940) — Command “no qos” did not reset port priority to “0”.

 CLI (PR_4108) — When reaching the inactivity timeout expiration after typing the CLI

command “enable” in a telnet session at operator mode, the text in the CLI prompt may get

corrupted with text similar to “gfs_alp_104Null Varbind”.