Release Notes G.07. 53

Software Fixes

Release G.05.01

 CLI (PR_4406) — The CLI command “show tech” causes an error message when the

command is executed from within config mode.

 CLI (PR_4474) — The prompt for saving the config does not handle a DISC character

appropriately.

 CLI/Timezone (PR_4524) — The switch time is wrong if CLI used to set timezone and

timezone may not operate properly after switch is rebooted. West of GMT is now a negative

offset and east of GMT is now a positive offset.

 Crash (PR_3711) — When hot-swapping transceivers multiple times, the switch may crash

with a message similar to: -> Software exception at port_sm.c:378 in -- 'mPmSlvCtrl'

 Crash (PR_4006) — If dynamic trunks are configured and the switch is rebooted, the switch

may crash with a message similar to: ->Software exception at rstp_dyn_reconfit.c:243 in --

'Lpmgr'

 Event Log (PR_3964) — Log messages for trunks and trunk members enhanced to be

easier to read.

 GARP/Event log (PR_4238) — GARP event log messages may be garbled.

 IGMP (PR_3248) — Interoperability issues with some Cisco devices (such as some Cisco

Catalyst 5000 & 6000 series switches) cause IGMP groups to be aged out of the switch's IGMP

tables prematurely.

 LACP/802.1x (PR_3868) — 802.1x and LACP trunks can co-exist on the same port. [Fix is

to make these trunks mutually exclusive.]

 LACP (PR_3954) — LACP maintains a dynamic trunk with only 1 port configured for the

trunk group.

 Menu (PR_2259) — The switch may not display the complete forwarding table while

performing a MAC address search.

 Menu (PR_2926) — Incorrect error message is displayed when attempting to create a VLAN

which exceeds the maximum number of VLANs supported. [Fix is to display an error message

similar to “Maximum number of VLANs (8) has already been reached.”]

 Menu (PR_3024) — Menu does not allow a port configuration change from a full- duplex/

flow control setting to a half-duplex/no flow control setting.

 Menu (PR_3509) — Menu does not allow trunks to be configured on transceiver ports that

have never had a transceiver installed before.

 Menu/CLI (PR_3920) — Modified help message for RSTP.

 Menu/VLAN (PR_3975, 3976) — The VLAN help text has been modified