Release Notes G.07. 53

Software Fixes
Release G.03.12
is a loop in the network), the address tables on the modules may get out of sync. This can
cause module-to-module communication problems for devices connected to the modules
whose address tables have become out of sync.
 XMODEM (PR_2999) — If the CLI "copy xmodem flash" command is used to download
the OS, the switch incorrectly displays one of the two following messages after the validate
and write process completes: 1) "User timeout, must hit ENTER before starting XMODEM
Transfer"; or 2) "Transfer terminated due to timeout"
Release G.03.12
 Never released.
 Update to the Manufacturing-only test routine.
Release G.03.11
 Never released.
 Update to the Manufacturing-only test routine.
Release G.03.10 6/28/01
 Performance enhancements to the message system, address learning, and SNMP.
Release G.03.09 6/27/01
 The switch's CDP packets have been modified to better interoperate with older Cisco IOS
versions. Certain legal CDP packets sent from the ProCurve switch could result in Cisco
routers, running older IOS versions, to crash. Note: The ProCurve switch's CDP packets are
legal both before and after this modification.
 IGMP (PR_2997) — Switch may stop sending IGMP queries on some VLANs.
 IGMP (PR_3045) — With IGMP enabled, toggling IGMP off and then on again causes all
querier intervals to be cut in half.
 LACP (PR_2979) — Ports are put into Standby mode when they shouldn't be.
 LACP (PR_3006) — Dynamic LACP creates 2 trunks when it should only create one.
 LACP (PR_3019) — When an LACP port is put into Standby mode, MAC address learning
on the switch may stop.
28