Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
4-6 Configuring the System
From a Telnet connection -
Telnet into the target hub using its assigned IP address.
From a remote modem connection -
Use a VT-100 terminal emulation package to connect to the
Com port that is attached to the modem. Configure the
connection for 9600 baud, 8 data bits, no parity bits, and 1
stop bit. Then dial in to the hub.
If the screen is blank, press the
<Enter> key several times
until the login screen appears. If diagnostic messages
indicate a failure, refer to
Troubleshooting in Appendix A.
Once the connection has been properly established, the login
screen for the on-board configuration program should appear.
2. The login procedure for the Hub-12TX VT-100 console
interface requires a password only. Access privileges are
Read/Write, and the default password is “admin.”
When logging into the Hub-12TXM, you must provide both a
user name and password. The default user names are
“admin” and “guest.” The Administrator account has
read/write access, and the Guest has read-only access. For
initial configurations, the password is blank. Just press the
<Enter> key. Administrator is the highest privilege level in
the Hub-12TXM VT-100 console interface. The
administrator should define a password, record it and put it in
a safe place. If you have not already done so, select User
Passwords under the Console Security menu in the VT-100
console interface and enter a password.
The configuration parameters you can access after logging into
the system are described in the following section.