Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
4-8 Configuring the System
**************************************************
* HP J3234A AdvanceStack 100Base-T Hub-12TX *
**************************************************
Hub Status
----------
Hub ID : 1
Isolate : NO
--------------------------------------------------
* Command Menu *
*------------------------------------------------*
* c = Change password *
* i = Change isolation status *
* e = Set Exp slot port status *
* h = Set Hub ID *
* s = Save changed value(s) *
* q = Exit menu *
--------------------------------------------------
Enter command :
Figure 4.1 Main Configuration Menu (Hub-12TX only)
Note: Input options for the selected item are displayed at the bottom of
the interface screen.
Menu selections are briefly described in following table.
Command Description
Change password
Press “c” to change the password. Passwords can be up to 5 characters long and are case
sensitive.
Isolate
Press “i” to isolate the hub from the stack’s collision domain.
Set Exp Slot status
Press “e” to display the menu for the Switch Port Module. Refer to the following table for a
description of the configuration options for this module.
Set hub ID
Press “h” to set the hub identifier to any value from 1 ~ 5. When stacked with
a management agent, note that all hub identifiers are automatically configured.
Save changed value(s)
Press “s” to write all configuration changes to nonvolatile memory. You must save your
changes, or they will be lost the next time you restart the system.
Exit
Press “q” to quit the configuration menu and return to the command prompt.
Table 4.1 Configuration Options in Main Menu (Hub-12TX only)