Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
Configuring the System 4-9
Configuring the Switch Port Module
To configure the Switch Port Module, press “e”. The following
menu will be displayed.
*************************************************
* HP J3234A AdvanceStack 100Base-T Hub-12TX *
*************************************************
Exp Slot Port Status
--------------------
Duplex : full-duplex
Forward : adaptive cut-through
Back Pressure : enable
-------------------------------------------------
* Command Menu *
-------------------------------------------------
* d = Set duplex mode *
* m = Set forward mode *
* b = Set back pressure *
* r = Return to Main Menu *
-------------------------------------------------
Enter command :
Figure 4.2 Configuration Menu for Switch Port Module (Hub-12TX
only)
Note: Input options for the selected item are displayed at the bottom of
the interface screen.
The current settings for the Switch Port Module are displayed
in the status field. Menu selections are briefly described in the
following table.
Command Description
Set duplex mode Press “d” to set the transmission mode to half duplex, full duplex or auto-negotiation. The
duplex mode setting is automatically saved to the hub’s EEPROM, therefore there is no need
to reconfigure if the power to the hub is lost.
Set forward mode Press “m” to set the frame forwarding mode to adaptive cut-through or store & forward.
Set back pressure Press “b” to enable or disable back pressure.
Return to Main Menu Press “r” to return to the Main Menu.
Table 4.2 Configuration Options for Switch Port Module (Hub-12TX
only)