Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
Configuring the System 4-13
Menu items are briefly described in the following table.
Field Description
Network Configuration Configures IP, IPX and SNMP parameters
SNMP Configuration Configures communities, as well as IP and IPX trap managers.
Hub Configuration Isolates/attaches a hub to the stack; sets bootup option; and also sets protocol status for
SNMP/IP and SNMP/IPX.
Port Configuration Disables/enables a port, shows link and partition state, as well as allowing you to set the
communication mode to full or half-duplex for the Switch Module.
Port Intrusion Control Sets the authorized entry address, and defines response for detected intrusion.
Backup Links Sets up to 10 pairs of backup link ports. Each pair contains a master and backup port. The
backup port is normally disabled. When the master port fails, the system disables the master
port and enables the backup port to maintain the link.
Table 4.5 System Configuration Menu
Changing the Network Configuration
To access the Hub-12TXM system with network tools such as
SNMP, Telnet or TFTP, you must configure the hub to use IP
or IPX protocols. Use the Network Configuration menu to
display the following screen:
HP J3233A AdvanceStack 100Base-T Hub-12TXM
Network Configuration
------------------------------
Back to Previous Menu
IP Configuration : IPX Configuration :
IP Address : 203.70.236.54 IPX Frame Type : IPX 802.2 FRAME
Subnet Mask : 255.255.255.0 Internal IPX Network : AC-B3-00-31
Gateway IP : 203.70.236.254 IPX Protocol : DISABLED
Serial IP : 203.70.236.9
IP Protocol : ENABLED
Update EEPROM
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.6 Network Configuration Menu