Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
4-14 Configuring the System
Menu items are briefly described in the following table.
Field Description
IP Configuration The hub system may be run on SNMP protocol over UDP/IP transport protocol. In this
environment, all systems on the Internet, such as network interconnection devices and
management stations are assigned an IP address.
IP Address IP address of this device.
Subnet Mask Subnet mask of this IP network. This mask identifies the host address bits used for routing to
specific subnets.
Gateway IP Gateway used in passing trap messages from the hub agent to the management station.
Serial IP IP address used to access hub configuration via an out-of-band SLIP connection to the
Console Port.
IP Protocol This can be enabled or disabled.
IPX Configuration
IPX Frame Type The selected format used on the LAN; i.e., this type is that used by the IPX network where the
hub is installed. If the specified frame type is not detected, the hub will automatically detect
the current type. (Values: 802.3, Ethernet II, SNAP, 802.2)
Internal IPX Network This address is composed of Net Number which identifies the IPX network number for the
connected slot.
IPX Protocol This can be enabled or disabled.
Update EEPROM This command saves the IP address for the selected segment to nonvolatile memory, and
makes it effective immediately.
Table 4.6 Network Configuration Menu