Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
4-20 Configuring the System
Hub Configuration
To configure a hub, select it from the list shown above. The
following Hub Configuration menu will appear, allowing you
set parameters for the base hub unit and the SNMP agent for a
Hub-12TXM.
HP J3233A AdvanceStack 100Base-T Hub-12TXM
Hub Configuration
-----------------------------------------
Back to Previous Menu
Hub ID : 1 Position : 1
Name : H/W Ver : 0
Type : J3233A-002 F/W Ver : 1.00
Isolated : NO
SNMP Agent :
Status : PRIMARY H/W Ver : 4
F/W Ver : 1.00
MAC Address : 0000E8-B30056
Bootup Option : NORMAL
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.12 Hub Configuration Menu
Menu items are briefly described in the following table.
Entity Field Description
(Hub Unit) Hub ID Hub identifier within the stack. (Up to 5 hubs may be connected via the Stacking
Cable’s management channel.)
Position The physical position in the stack.
Name Any user-defined name for the selected hub.
Type Indicates hub type as HP J3233A or HP J3234A.
H/W Ver Indicates the current hardware version number of the hub board.
F/W Ver Indicates the current firmware version number of the hub board.
Isolated Enables you to remove a hub from the collision domain of the stack
SNMP Agent Status Defines the status of the management agent as Primary or Backup.
H/W Ver Indicates the current hardware version number for the management board.
F/W Ver Indicates the current firmware version number for the management board.
Mac Address MAC address of the management agent.