Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
Configuring the System 4-35
agent will not accept it. Also be sure that you have already set
the required bootup option for the target hub under the Hub
Configuration menu.
Download status is indicated by messages at the bottom of the
screen. Firmware is first loaded into a temporary buffer. If you
selected download for permanent use, it will then be transferred
to nonvolatile memory. After you download the firmware, the
agent will be reset and you will have to log into the VT-100
console interface again. The following screen shows an
example of the TFTP download menu.
HP J3233A AdvanceStack 100Base-T Hub-12TXM
TFTP Download
------------------
Back to Previous Menu
Download Server IP : 203.70.236.52
Download Filename : *.bin
Download Mode : PERMANENT
Start Download
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.28 TFTP Download Menu
Menu items are briefly described in the following table.
Field Description
Download Server IP IP address of a TFTP server. (TFTP stands for Trivial File Transfer Protocol.)
Download Filename The *.bin file to download.
Download Mode You can download to permanent flash ROM or temporary storage in RAM (for test purposes).
However, if you download to temporary memory, this firmware will be lost upon power off. To
update new agent firmware for permanent use, it must be downloaded to flash ROM.
Start Download Command to start the download.
Table 4.22 TFTP Download Menu