Switch 7700 Command reference Guide, v2.0

106 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
Description
Using the display ip routing-table acl command, you can view the route
filtered through the specified access control list (ACL).
This command is used to display the routes that passed the filtering rules in the
specified ACL.
The command only displays routes that passed basic ACL filtering rules.
Example
To display a summary of the active routes filtered through IP ACL 1, enter the
following:
<SW7700>display ip routing-table acl 1
The information displays in the following format:
Routes matched by access-list 1:
Summary count: 4
Destination/Mask Proto Pre Cost Nexthop Interface
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoopBack0
169.0.0.0/8 Static 60 0 2.1.1.1 LoopBack1
169.0.0.0/15 Static 60 0 2.1.1.1 LoopBack1
To display the verbose information of the active and inactive routes that are
filtered through IP ACL 1.
<SW7700>display ip routing-table acl 1 verbose
The information displays in the following format:
Routes matched by access-list 1:
Generate Default: no
+ = Active Route, - = Last Active, # = Both* = Next hop in use
Summary count:5
**Destination: 127.0.0.0 Mask: 255.0.0.0
Protocol: #Direct Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Multicast Unicast>
Age: 3:47Metric: 0/0
**Destination: 127.0.0.1 Mask: 255. 255. 255. 255
Protocol: #Direct Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NotInstall NoAdvise Int ActiveU Retain Gateway Multicast
Unicast>
Age: 3:47Metric: 0/0
**Destination: 179.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference: -60
*NextHop: 4.1.1.1
Vlinkindex: 0
State: <Int Hidden Static Unicast>
Age: 3:47Metric: 0/0
**Destination: 169.0.0.0 Mask: 255.0.0.0