Switch 7700 Command reference Guide, v2.0

RIP Configuration Commands 119
Parameter
gateway ip_prefix_name Enter the name of the address prefix list. This is used to
filter the addresses of this neighboring routers advertising the routing information.
acl_number Enter an Access Control List (ACL) number. This is used to filter the
destination addresses of the routing information.
ip_prefix_name Enter the name of the address prefix list. This is used to filter the
destination addresses of the routing information.
Description
■ Use the filter-policy gateway import command to configure the switch to
filter the routing information received from a specified address.
■ Use the undo filter-policy gateway import command to configure the
switch not to filter the routing information received from the specified address.
■ Use the filter-policy import command to configure the switch to filter
global routing information.
■ Use the undo filter-policy import command to disable filtering of
received global routing information.
By default, RIP does not filter the received routing information.
Related commands: acl, filter-policy export, ip ip-prefix.
Example
To configure the filtering of the global routing information using acl 3, enter the
following:
[SW7700-rip]filter-policy 3 import
host-route Syntax
host-route
undo host-route
View
RIP view
Parameter
None
Description
Using the host-route command, you can configure RIP to accepts host routes.
This is the default.
Using the undo host-route command, you can configure RIP to reject host
routes.