Switch 7700 Command reference Guide, v2.0

RIP Configuration Commands 125
[SW7700-Vlan-interface1]rip authentication-mode md5 type nonstandard
To set MD5 authentication on Vlan-interface 1 with the key string set to “aaa”
and the packet type set to
usual, enter the following:
[SW7700]interface Vlan-interface 1
[SW7700-Vlan-interface1]rip version 2
[SW7700-Vlan-interface1]rip authentication-mode md5 key-string aaa
[SW7700-Vlan-interface1]rip authentication-mode md5 type usual
rip input Syntax
rip input
undo rip input
View
VLAN interface view
Parameter
None
Description
Using the rip input command, you can allow an interface to receive RIP packets.
By default, all interfaces except loopback interfaces are able to receive RIP packets.
Using the undo rip input command, you can block an interface from receiving
RIP packets.
This command is used in conjunction with two other two commands: rip output
and
rip work. The rip input and rip output commands control, respectively,
the receipt and the transmission of RIP packets on an interface. The
rip work
command allows both receipt and tranmission of RIP packets.
Related commands: rip output, rip work.
Example
To set the interface Vlan-interface 1 not to receive RIP packets, enter the
following:
[SW7700-Vlan-interface1]undo rip input
rip metricin Syntax
rip metricin value
undo rip metricin
View
VLAN interface view
Parameter
value: Enter an additional route metric added when receiving a packet, ranging
from 0 to 16. By default, the value is 0.