Switch 7700 Command reference Guide, v2.0

126 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
Description
Using the rip metricin command, you can configure an additional route metric
to be added to the route when an interface receives RIP packets.
Using the undo rip metricin command, you can restore the default value of this
additional route metric.
Related command: rip metricout.
Example
To set the additional route metric to 2 when the interface Vlan-interface 1 receives
RIP packets, enter the following:
[SW7700]interface Vlan-interface 1
[SW7700-Vlan-interface1]rip metricin 2
rip metricout Syntax
rip metricout value
undo rip metricout
View
VLAN interface view
Parameter
value: Enter an additional route metric added when transmitting a packet,
ranging from 1 to 16. By default, the value is 1.
Description
Using the rip metricout command, you can configure an additional route
metric to be added to a route when an interface transmits RIP packets.
Using the undo rip metricout command, you can restore the default value of
the additional route metric.
Related command: rip metricin.
Example
To set the additional route metric to 2 when the interface Vlan-interface 1
transmits RIP packets, enter the following:
[SW7700]interface Vlan-interface 1
[SW7700-Vlan-interface1]rip metricout 2
rip output Syntax
rip output
undo rip output
View
VLAN interface view