Switch 7700 Command reference Guide, v2.0

Integrated IS-IS Configuration Commands 183
View
User view
Parameter
system-id: Specifies the system ID of IS-IS neighbor.
Description
Use the reset isis peer command to reset the specified IS-IS peer.
This command is used when you want to reconfigure a certain neighbor.
Example
Clear the IS-IS neighbor whose system ID is 0000.0c11.1111.
<SW7700>reset isis peer 0000.0c11.1111
set-overload Syntax
set-overload
undo set-overload
View
IS-IS view
Parameter
None
Description
■ Use the set-overload command to set overload flag for the current router.
■ Use the undo set-overload command to cancel the overload flag.
By default, no overload flag is set.
If a router is configured with the overload flag, the routes it calculates will be
ignored by other routers in SPF calculation. (However the directly connected routes
will not be ignored.) And other routers should not send this router the packets
which should be forwarded by it.
Example
Set overload flag on the current router.
[SW7700-isis]set-overload
silent-interface Syntax
silent-interface silent_interface_type silent_interface_number
undo silent-interface silent_interface_type silent_interface_number
View
IS-IS view