Switch 7700 Command reference Guide, v2.0

BGP Configuration Commands 223
■ Use the undo peer timer command to restore the timer to the default value.
The timer configured by using this command has a higher priority than the one
configured by using the
timer command.
Example
Configure Keepalive and Holdtime intervals of the peer group “test”.
[SW7700-bgp]peer test timer keep-alive 60 hold 180
reflect between-clients Syntax
reflect between-clients
undo reflect between-clients
View
BGP view
Parameter
none
Description
■ Use the reflect between-clients command to configure the between-client
reflection of a route.
■ Use the undo reflect between-clients command to disable this function.
By default, the reflection between clients is disabled.
Related commands: reflect cluster-id, peer reflect-client.
Example
Disable the reflection between clients.
[SW7700-bgp]undo reflect between-clients
reflect cluster-id Syntax
reflect cluster-id { cluster_id | address }
undo reflect cluster-id
View
BGP view
Parameter
cluster_id: Specify the cluster ID of the route reflector with the range from 1 to
4294967295.
address: Used as the interface address of the route reflector’s cluster ID.
Description
■ Use the reflect cluster-id command to configure the cluster ID of the
route reflector.