Switch 7700 Command reference Guide, v2.0

232 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
Example
Define one apply sub-statement. When it is used for setting route information
attribute, it sets the route source of BGP route information as igp.
[SW7700-route-policy]apply origin igp
apply tag Syntax
apply tag value
undo apply tag
View
Route policy view
Parameter
value: Specifies the tag value of route information.
Description
■ Use the apply tag command to configure to set the tag area of OSPF route
information. This command is one of attribute apply sub-statements of
Route-policy.
■ Use the undo apply tag command to cancel the apply sub-statement.
Related command: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply
ip next-hop
, apply local-preference, apply cost and apply origin.
Example
Define one apply sub-statement. When it is used for setting route information
attribute, it sets the tag area of route information as 100.
[SW7700-route-policy]apply tag 100
display ip ip-prefix Syntax
display ip ip-prefix [ ip_prefix_name ]
View
All views
Parameter
ip_prefix_name: Specifies displayed address prefix list name.
Description
Use the display ip ip-prefix command to view the address prefix list.
Related command: ip ip-prefix.