Switch 7700 Command reference Guide, v2.0

242 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
Route Capacity
Configuration
Commands
This section describes the commands you can use to configure route capacity on
the Switch 7700.
display memory limit Syntax
display memory limit
Mode
All views
Parameter
None
Description
Use the display memory limit command to the memory setting and state
information related to the Ethernet switch capacity, including available memory
and state information about connections such as times for disconnecting
connections, times for reestablishing connections and whether or not the current
system is in the emergent state.
Example
Display the current memory setting and state information.
<SW7700>display memory limit
Current memory limit configuration information:
system memory safety: 4
system memory limit: 2
auto-establish enabled
Free Memory: 17781708 (Byte)
The state information about connection:
The times of disconnect: 0
The times of reconnect: 0
The current state: Normal
The information displayed by this command includes the Ethernet switch memory
limit, the size of the idle memory, the times of the connection disconnecting, the
times of the connection reestablishment and the current state.
The displayed information is described specifically in the following table:
Tab le 17 The description for the information displayed by the display memory limit
command
Item Description
system memory safety:4 The safety value of the Ethernet switch memory is 4Mbytes
system memory limit: 2 The lower limit of the Ethernet switch memory is 2Mbytes.
auto-establish enabled The system allows recovering the connection automatically. (If
the automatic recover is disabled, the "auto-establish disabled"
will be displayed.)
Free Memory: 17781708
(Byte)
The size of the current idle memory is 17781708 bytes, that is,
17,782Mbytes.