Switch 7700 Command reference Guide, v2.0

252 CHAPTER 6: USING MULTICAST PROTOCOL COMMANDS
We can know from the information listed above that :
■ There is a multicast group in VLAN 2;
■ The router port is Ethernet 1/0/1;
■ The address of the multicast group is 230.45.45.1;
■ The member of the IP multicast group is Ethernet 1/0/12;
■ MAC multicast group is 0100-5e2d-2d01;
■ The member of the MAC multicast group is Ethernet 1/0/12¡£
display igmp-snooping
statistics
Syntax
display igmp-snooping statistics
View
All views
Parameter
None
Description
Use the display igmp-snooping statistics command to view the statistics
information on IGMP Snooping.
This command displays the statistics information about IGMP Snooping of
Ethernet switch. It displays the information such as number of received general
IGMP query packets, received IGMP specific query packets, received IGMP Version
1 and Version 2 report packets, received IGMP leave packets and error packets,
and sent IGMP specific query packets.
Related command: igmp-snooping.
Example
Display statistics information about IGMP Snooping.
<SW7700>display igmp-snooping statistics
Received IGMP general query packet(s) number:0.
Received IGMP specific query packet(s) number:0.
Received IGMP V1 report packet(s) number:0.
Received IGMP V2 report packet(s) number:0.
Received IGMP leave packet(s) number:0.
Received error IGMP packet(s) number:0.
Sent IGMP specific query packet(s) number:0.
igmp-snooping Syntax
igmp-snooping { enable | disable }
undo igmp-snooping
View
System view