Switch 7700 Command reference Guide, v2.0

274 CHAPTER 7: USING QOS/ACL COMMANDS
Description
Use the display time-range command to view the configuration and status of
the current time range. You will see the active or inactive state outputs
respectively.
Note that the system has a delay of about 1 minute when updating the ACL state,
while the
display time-range command applies the current time. Therefore
when
display time-range displays that a time range is active, the ACL using it
may not have been activated. This is a kind of normal case.
Example
Display the configuration of all the time ranges.
<SW7700>display time-range all
Current time is 14:36:36 4-3-2003 Thursday
Time-range : hhy ( Inactive )
from 08:30 2-5-2005 to 18:00 2-19-2005
Time-range : hhy1 ( Inactive )
from 08:30 2-5-2003 to 18:00 2-19-2003
Display the time range named tm1.
<SW7700>display time-range tm1
Current time is 14:37:31 4-3-2003 Thursday
Time-range : tm1 ( Inactive )
from 08:30 2-5-2005 to 18:00 2-19-2005
packet-filter Syntax
packet-filter inbound { [ ip-group { acl-number | acl-name } [ rule
rule ] ] | [ link-group { acl-number | acl-name } [ rule rule ] ] }
undo packet-filter inbound { [ ip-group { acl-number | acl-name } [
rule rule ] ] | [ link-group { acl-number | acl-name } [ rule rule ]
] }
View
Ethernet port view.
Parameter
inbound: specify the traffic received by the Ethernet port.
ip-group { acl-number | acl-name }:activate the IP ACLs. IP ACLs include
basic, advanced and interface-based ACLs.
acl-number specifies the ACL number,
ranging from 100 to 199 and from 1000 to 1999.
acl-name specifies the ACL
name with a character string started with English letters (that is [a to z, A to Z]),
excluding space and quotation marks.
link-group { acl-number | acl-name }: activate the L2 ACL. acl-number
specifies the ACL number, ranging from 200 to 299.
acl-name specifies the ACL
name with a character string started with English letters (that is [a to z, A to Z]),
excluding space and quotation marks.