Switch 7700 Command reference Guide, v2.0

802.1x Configuration Commands 349
interface-list: Ethernet interface list including several Ethernet interfaces,
expressed in the format interface-list = { interface-num [ to interface-num ] } & <
1-10 >. interface-num specifies a single Ethernet interface in the format
interface-num = { interface-type interface-num | interface-name }, where
interface-type specifies the interface type, interface-num specifies the interface
number and interface-name specifies the interface name. For the respective
meanings and value ranges, read the Parameter of the Port Command Manual
section.
Description
Use the display dot1x command to view the relevant information of 802.1x,
including configuration information, running state (session connection
information) and relevant statistics information.
By default, all the relevant 802.1x information about each interface will be
displayed.
This command can be used to display the following information on the specified
interface: 802.1x configuration, state or statistics. If no port is specified when
executing this command, the system will display all 802.1x related information.
For example, 802.1x configuration of all ports, 802.1x session connection
information, and 802.1x data statistical information. The output information of
this command can help the user to verify the current 802.1x configurations so as
to troubleshoot 802.1x.
Related commands: reset dot1x statistics, dot1x, dot1x retry, dot1x
max-user
, dot1x port-control, dot1x port-method, dot1x timer.
Example
Display the configuration information of 802.1x.
<SW7700>display dot1x
Equipment 802.1X protocol is enabled
DHCP-launch is disabled
EAP-relay is enabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
Configure: Transmit Period 000030 s, Commit Period 000015 s
Quiet Period 000060 s, Quiet Period Timer is disabled
Supp Timeout 000030 s, Server Timeout 000100 s
The Max-Req 000003
Total maximum on-line user number is 4096
Total current on-line user number is 0