Switch 7700 Command reference Guide, v2.0

350 CHAPTER 9: USING AAA AND RADIUS COMMANDS
Ethernet1/0/1 is link-down
802.1X protocol is disabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
The port is a(n) authenticator
Authenticate Mode is auto
Port Control Type is Mac-based
Max on-line user number is 1024
… (Omitted)
dot1x Syntax
dot1x [ interface interface-list ]
undo dot1x [ interface interface-list ]
View
System view
Ethernet port view
Parameter
interface interface-list: Ethernet port list including several Ethernet ports.
interface-list = { interface-num [ to interface-num ] } & < 1-10 >. interface-num
specifies a single Ethernet port in the format interface-num = { interface-type
interface-num | interface-name }, where interface-type specifies the port type,
interface-num specifies the port number and interface-name specifies the port
name. For the respective meanings and value ranges, read the Parameter of the
Port Configuration section.
Description
■ Use the dot1x commandto enable 802.1x on the specified port or globally (i.e.,
on the current device).
■ Use the undo dot1x command to disable the 802.1x on the specified port or
globally.
By default, 802.1x is disabled on all the ports and globally on the device.
This command is used to enable the 802.1x on the current device or on the
specified port. When it is used in system view, if the parameter ports-list is not
specified, 802.1x will be globally enabled. If the parameter ports-list is specified,
802.1x will be enabled on the specified port. When this command is used in
Ethernet port view, the parameter interface-list cannot be input and 802.1x can
only be enabled on the current port.
The configuration command can be used to configure the global or port 802.1x
performance parameters before or after 802.1x is enabled. Before 802.1x is
enabled globally, if the parameters are not configured globally or for a specified
port, they will maintain the default values.
After the global 802.1x performance is enabled, only when port 802.1x
performance is enabled will the configuration of 802.1x become effective on the
port.