Switch 7700 Command reference Guide, v2.0

354 CHAPTER 9: USING AAA AND RADIUS COMMANDS
interface interface-list: Ethernet interface list including several Ethernet
interfaces, expressed in the format interface-list = { interface-num [ to
interface-num ] } & < 1-10 >. interface-num specifies a single Ethernet interface in
the format interface-num = { interface-type interface-num | interface-name },
where interface-type specifies the interface type, interface-num specifies the
interface number and interface-name specifies the interface name. For the
respective meanings and value ranges, see the parameters of the Port Command
chapter.
Description
■ Use the dot1x port-control command to configure the mode for 802.1x to
perform access control on the specified interface.
■ Use the undo dot1x port-control command to restore the default access
control mode.
By default, the value is auto.
This command is used to set the mode, or the interface state, for 802.1x to
perform access control on the specified interface. This command has effect on the
interface specified by the parameter interface-list when executed in system view. It
has effect on all the interfaces when no interface is specified. The parameter
interface-list cannot be input when the command is executed in Ethernet port
view and it has effect only on the current interface.
Related command: display dot1x.
Example
Configure the interface Ethernet 1/0/2 to be in force-unauthorized state.
[SW7700]dot1x port-control force-unauthorized interface ethernet
1/0/2
dot1x port-method Syntax
dot1x port-method { macbased | portbased } [ interface
interface-list ]
undo dot1x port-method [ interface interface-list ]
View
System view
Ethernet interface view
Parameter
macbased: Configures the 802.1x authentication system to perform
authentication on the supplicant based on MAC address.
portbased: Configures the 802.1x authentication system to perform
authentication on the supplicant based on interface number.
interface interface-list: Ethernet interface list including several Ethernet
interfaces, expressed in the format interface-list = { interface-num [ to
interface-num ] } & < 1-10 >. interface-num specifies a single Ethernet interface in