Switch 7700 Command reference Guide, v2.0

36 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
undo screen-length
View
User interface view
Parameter
screen-length: Enter the maximum number of information lines that you want
to display on a terminal screen, ranging from 0 to 512. The default is 24.
Description
■ Use the command screen-length to configure how many information lines
(maximum) will be displayed on the screen of a terminal.
■ Use the command undo screen-length to restore the default of 24 lines.
To disable this function, that is to allow an unlimited number of information lines,
enter the parameter as
0.
Example
To configure a terminal to display 20 lines of information, enter the following:
[SW7700-ui-aux0]screen-length 20
send Syntax
send { all | type number | index }
View
User view
Parameter
all: Sends a message to all user interfaces.
type number: Enter the type and type number of the user interface that you
want to send a message to.
index: Enter the index number of the interface that you want to send a message
to.
Description
Use the send command to send messages to other user interfaces.
Example
To send a message to all the user interfaces, enter the following:
<SW7700>send all
service-type telnet level Syntax
service-type telnet level level
undo service-type telnet level