Switch 7700 Command reference Guide, v2.0

AAA Configuration Commands 365
Parameter
domain isp-name: Configures to display all the local users in the specified ISP
domain.
isp-name specifies the ISP domain name with a character string not
exceeding 24 characters. The specified ISP domain shall have been created.
idle-cut: Configures to display the local users according to the state of idle-cut
function.
disable means that the user disables the idle-cut function and enable
means the user enables the function.
service-type: Configures to display local user of a specified type. telnet means
that: the specified user type is telnet.
ftp means that: the specified user type is
ftp.
lan-access means that the specified user type is lan-access which mainly
refers to Ethernet accessing users, 802.1x supplicants for example.
state { active | block }: Configures to display the local users in the specified
state.
active means that the system allows the user requesting network service
and
block means the system does not allow the user requesting network service.
user-name user-name: Configures to display a user specified with user-name.
user-name is the argument specifying the username. It is a character string not
exceeding 32 characters, excluding “/”, “:”, “*”, “?”, “<” and “>”. The @
character can only be used once in one username. The pure username (the part
before @, namely the user ID) cannot exceed 24 characters.
vlan vlanid: Configures to display the users belonged to specified VLAN.
vlanid is the integer, ranging from 1 to 4094.
Description
Use the display local-user command to view the relevant information of all
the local users or the specified one(s).
This command displays the relevant information about a specified or all the local
users. The output can help you with the fault diagnosis and troubleshooting
related to local user.
Related command: local-user.
Example
Display the relevant information of all the local users.
<SW7700>display local-user
The contents of local user xxx:
State: Active ServiceType Mask:
Idle Cut: Disable
AccessLimit: Disable Current AccessNum: 0
Bind location: Disable
Vlan ID: Disable
Total 1 local user(s) Matched,1 listed.
domain Syntax
domain [ isp-name | default { disable | enable isp-name }]
undo domain isp-name