Switch 7700 Command reference Guide, v2.0

388 CHAPTER 9: USING AAA AND RADIUS COMMANDS
is controlled by the RADIUS server response timeout timer in the switch system.
This command is used to set this timer.
Setting a suitable timer according to the network situation will enhance the
system performance.
Related commands: radius scheme, retry.
Example
Set the response timeout timer of RADIUS server group, 3Com, to 5 seconds.
[SW7700-radius-3Com]timer 5
timer
realtime-accounting
Syntax
timer realtime-accounting minute
undo timer realtime-accounting
View
RADIUS server group view
Parameter
minute: Real-time accounting interval, ranging from 3 to 60 and measured in
minutes. By default, the value is 12.
Description
■ Use the timer realtime-accounting command to configure the real-time
accounting interval.
■ Use the undo timer realtime-accounting command to restore the default
interval.
To implement real-time accounting, it is necessary to set a real-time accounting
interval. After the attribute is set, NAS will transmit the accounting information of
online users to the RADIUS server regularly.
The value of minute is related to the performance of NAS and RADIUS server. The
smaller the value is, the higher the requirement for NAS and RADIUS server is.
When there are a large amount of users (more than 1000, inclusive), we suggest a
larger value. The following table recommends the ratio of
minute value to number
of users.
Related commands: retry realtime-accounting, radius scheme.
Tab le 29 Recommended ratio of minute to number of users
Number of users
Real-time accounting
interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
1000 15