Switch 7700 Command reference Guide, v2.0

392 CHAPTER 10: USING RELIABILITY COMMANDS
Description
■ Use the debugging vrrp command to enable VRRP debugging.
■ Use the undo debugging vrrp command to disable VRRP debugging. By
default, VRRP debugging is disabled.
Example
Enable VRRP state debugging.
<SW7700>debugging vrrp state
display vrrp Syntax
display vrrp [{ interface | statistics } vlan-interface
interface-num ] [ virtual-router-ID ]
View
All views.
Parameter
interface-name: Interface name, the interface form is VLAN-interface
interface-num.
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.
Description
Use the display vrrp command to display information about the VRRP state.
This command is used to view the information about the VRRP state and
configuration parameters. If the interface name and virtual router ID are not
specified, the state information about all the virtual routers on the switch will be
displayed. If only the interface name is specified, the state information about all
the virtual routers on the interface will be displayed. If the interface name and
virtual router ID are specified, the state information about the specified virtual
router on the interface will be displayed.
Example
Display the information about the virtual routers on VLAN-interface 20 of the
switch.
[SW7700]display vrrp interface vlan 20
Vlan-interface20|Virtual Router 10
State : Initialize
Virtual IP : 10.10.10.2
Priority : 100
Preempt : YES Delay Time : 0
Timer : 3
Auth Type : NONE
vrrp
authentication-mode
Syntax
vrrp authentication-mode type [ key ]
undo vrrp authentication-mode