Switch 7700 Command reference Guide, v2.0

MAC Address Table Management Commands 431
Example
Display the aging time of the dynamic entry in the MAC address table.
[SW7700]display mac-address aging-time
mac-address timer: 300s
The above information indicates that the aging time of the dynamic entry in the
MAC address is 300s.
display mac-address Syntax
display mac-address [ static | dynamic ] [ [ interface
{ interface-name | interface-type interface-num } ] [ vlan vlan-id ]]
View
All views
Parameter
static: Static table entry, lost after resetting switch.
dynamic: Dynamic table entry, which will be aged.
interface-type: Specify the interface type.
interface-num: Specify the interface number.
interface-name: Specify the interface name.
For details about the interface-type, interface-num and interface-name
parameters, refer to the Port Configuration in this manual.
vlan-id: Specify the VLAN ID.
mac-addr: Specify the MAC address.
Description
Using the display mac-address command, you can display MAC address table
information.
When managing the Layer-2 addresses of the switch, the administrator can
perform this command to view such information as the Layer-2 address table,
address status (static or dynamic), Ethernet port of the MAC address, VLAN of the
address, and system address aging time.
For the related commands, see mac-address, mac-address timer.
Example
Show the information of the entry with MAC address at 00e0-fc01-0101
[SW7700]display mac-address 00e0-fc01-0101
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
00e0-fc01-0101 N/A Config static Ethernet1/0/1 NOAGED