Switch 7700 Command reference Guide, v2.0

Device Management Commands 441
reboot slot Syntax
reboot [ slot slot-num ]
View
User view
Parameter
slot-num: Specifies the physical card number, generally taken 0.
Description
Using the reboot slot command, you can reset the whole system.
If no parameter is specified with the reboot command, it will reset the Ethernet
switch. You can use the
reboot command to reset the card, when the Ethernet
switch fails.
Example
Reset the card in Slot 1.
<SW7700>reboot slot 1
set backboard view
Syntax
set backboard view value
View
System view
Parameter
value: 0-5 indicates value of backplane configuration.
Description
Using the set backboard view value command, you can set backplane
configuration.
Example
Set backboard view.
[SW7700] set backboard view 1
Configuration of System Back Board Mode
Default settings are in square brackets '[]'.
The new configuration will be as following:
|Slot No. |Brd Type| Slot Band Width |Brd Available
| 1 |NONE | 8G |NO
| 2 |NONE | 8G |NO
| 3 |NONE | 4G |NO
| 4 |LS81FT48| 4G |YES
| 5 |NONE | 4G |NO
| 6 |NONE | 4G |NO
Are you sure the configuration is correct, continue?[Y/N]