Switch 7700 Command reference Guide, v2.0

448 CHAPTER 11: USING SYSTEM MANAGEMENT COMMANDS
interface-num: Specify the Ethernet port number.
Description
Using the display debugging command, you can display the enabled debugging
process.
Show all the enabled debugging when there is no parameter.
For the related commands, see debugging.
Example
Show all the enabled debugging.
<SW7700>display debugging
IP packet debugging switch is on.
display
saved-configuration
Syntax
display saved-configuration
View
All views
Parameter
None
Description
Using the display saved-configuration command, you can display the
configuration files in the flash memory of Ethernet Switch.
If the Ethernet Switch works abnormally after electrified, execute the display
saved-configuration
command to view the startup configuration of the
Ethernet Switch.
For the related commands, see save, reset saved-configuration, display
current-configuration.
Example
Display configuration files in flash memory of Ethernet Switch.
<SW7700>display saved-configuration
#
hostname SW7700
#
no hdp run
#
no htp run
#
radius-server host default
#
aaa authentication Default radius next local
aaa accounting Default enable offline
user user1 state active service-type ftp ftp-directory flash: