Switch 7700 Command reference Guide, v2.0

460 CHAPTER 11: USING SYSTEM MANAGEMENT COMMANDS
This command takes effect only after the system logging is enabled.
For the related commands, see info-center enable, display info-center.
Example
Configure to send log information to the UNIX workstation at 202.38.160.1.
[SW7700]info-center loghost 202.38.160.1
info-center monitor
channel
Syntax
info-center monitor channel { channel-number | channel-name }
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, the system has
ten channels.
channel-name: Specify the channel name.
Description
Using the info-center monitor channel command, you can set the channel to
output the log information to the user terminal.
By default, Ethernet switches do not output log information to user terminal.
This command takes effect only after system logging is started.
For the related commands, see info-center enable, display info-center.
Example
Configure channel 0 to output log information to user terminal.
[SW7700]info-center monitor channel 0
info-center snmp
channel
Syntax
info-center snmp channel { channel-number | channel-name }
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, the system has
ten channels. By default, channel 5 is used.
channel-name: Specify the channel name.
Description
Using the info-center snmp channel command, you can specify new channel
for transmitting the SNMP information.