Switch 7700 Command reference Guide, v2.0

SNMP Configuration Commands 475
Parameter
group_name: Enter a group name, up to 32 characters in length.
read-view: Configures read-only view settings.
read_view: Enter a read-only view name, up to 32 characters in length.
write-view: Configures read and write view settings.
write_view: Enter a read and write view name, up to 32 characters in length.
notify: Configures notify view settings.
notify_view: Enter a notify view name, up to 32 characters in length.
acl acl-list: Enter the access control list for this group name.
v3: Configures SNMP version 3.
authentication: Specifies that the packet is authenticated without encryption.
This parameter is only available if you enter
v3.
privacy: Specifies that the packet is authenticated and encrypted. This parameter
is only available if you enter
v3.
Description
Using the snmp-agent group command, you can configure a new SNMP group,
that is, map an SNMP user to SNMP view.
Using the undo snmp-agent group command, you can delete a specified SNMP
group.
3Com recommends that you do not use the notify notify_view parameters
when configuring an SNMP group, for the following reasons:
■ The snmp-agent target-host command automatically generates a
notify_view for a user, and adds it to the corresponding group.
■ Any change of the SNMP group notify_view will affect all the users related to
this group.
Example
To create an SNMP group named 3Com, enter the following:
[SW7700]snmp-agent group v3 3Com
snmp-agent mib-view Syntax
snmp-agent mib-view { included | excluded } view-name oid-tree
undo snmp-agent mib-view view-name
View
System view