Switch 7700 Command reference Guide, v2.0

48 CHAPTER 2: USING PORT COMMANDS
display mirroring-group Syntax
display mirroring-group [ mirror_group_number ]
View
System view
Parameter
None.
Description
Use the display mirroring-group command to display the ports assigned to a
specific mirror group.
Example
To display information on mirroring group 1 enter the following:
[SW7700]display mirroring-group 1
Tab le 3 Output description of the display interface command
Field Description
Ethernet1/0/1 current state Indicates the current state of the Ethernet port
(enabled or disabled)
IP Sending frames’ format Displays the Ethernet frame format
Hardware address Displays the port hardware address
Description Displays the port description
The Maximum Transmit Unit Indicates the maximum transmit unit
Media type Indicates the type of media
loopback not set Displays the port loopback test state
Port hardware type Displays the port hardware type
100Mbps-speed mode, full-duplex mode,
link speed type is autonegotiation, link
duplex type is autonegotiation
Indicates that the duplex mode and the rate have
been auto-negotiated with the connected device,
and have been set to 100Mbps full-duplex.
The Maximum Frame Length Indicates the maximum length of the Ethernet
frames that can pass through the port
Allow jumbo frame to pass Indicates that jumbo frame are allowed to pass
through the port
PVID Indicates the port default VLAN ID.
Mdi type Indicates the cable type
Port link-type Indicates the port link type
Tagged VLAN ID Indicates the VLANs with packets tagged
Untagged VLAN ID Indicates the VLANs with packets untagged
Last 5 minutes input rate 229 bytes/sec,
2 packets/sec
Last 5 minutes output rate 25 bytes/sec,
0 packets/sec
Displays the input/output rate and the passing
packet number on this port in the last 5 minutes