Switch 7700 Command reference Guide, v2.0

492 CHAPTER 11: USING SYSTEM MANAGEMENT COMMANDS
undo debugging ntp-service { access | adjustment | authentication |
event | filter | packet | parameter | refclock | selection |
synchronization | validity | all }
View
User view.
Parameter
access: NTP access control debugging.
adjustment: NTP clock adjustment debugging.
all: All NTP debugging functions.
authentication: NTP authentication debugging.
event: NTP event debugging.
filter: NTP filter information debugging.
packet: NTP packet debugging.
parameter: NTP clock parameter debugging.
refclock: NTP reference clock debugging.
selection: NTP clock selection information debugging.
synchronization: NTP clock synchronization information debugging.
validity: NTP remote host validity debugging
Description
Using debugging ntp-service command, you can debug different NTP services.
Using
undo debugging ntp-service command, you can disable corresponding
debugging function.
By default, no debugging function is enabled.
Example
Enable NTP access control debugging.
<SW7700>debugging ntp-service access
display ntp-service
sessions
Syntax
display ntp-service sessions [ verbose ]
View
All views.
Parameter
verbose: Indicate to display the detail information about the sessions.