Switch 7700 Command reference Guide, v2.0

NTP Configuration Commands 493
Description
Using display ntp-service sessions command, you can display the status of
all the sessions maintained by NTP service provided by the local equipment.
By default, the status of all the sessions maintained by NTP service provided by the
local equipment will be displayed.
When you configure this command without the verbose parameter, the Ethernet
switch will display the brief information about all the sessions it maintains.
With the verbose parameter configured, Ethernet switch will display the detail
information about all the sessions it maintains.
Example
<SW7700>display ntp-service sessions
The information displays in the following format:
source refid st now poll reach delay offset disp
********************************************************************
[12345]212.125.95.4 131.188.3.221 2 18 64 377 339.8 10.8
0.9
note: 1 source(master),2 source(peer),3 selected,4 candidate,5
configured
display ntp-service
status
Syntax
display ntp-service status
Views
All views.
Parameter
None
Description
Using command display ntp-service status, you can display the NTP service
status.
Example
<SW7700>display ntp-service status
The information displays in the following format:
clock status: unsynchronized
clock stratum: 16
reference clock ID: none
nominal frequency: 100.0000 Hz
actual frequency: 100.0000 Hz
clock precision: 2^17
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 0.00 ms
peer dispersion: 0.00 ms
reference time: 00:00:00.000 UTC Jan 1 1900(00000000.00000000)