Switch 7700 Command reference Guide, v2.0

58 CHAPTER 2: USING PORT COMMANDS
You can use the interface_name at this command. This is made up of
interface_type and interface_number parameters combined as a single
parameter, for example Ethernet0/0/1.
Description
Use the reset counters interface command to reset the statistical information
on the port and count the related information again on the port for the user.
If you do not enter a port type, or port type and port number, information is
cleared from all ports on the Switch.
If 802.1X is enabled, port information cannot be reset.
Example
To reset statistical information on the Ethernet port Ethernet1/0/1, enter the
following:
<SW7700>reset counters interface ethernet1/0/1
shutdown Syntax
shutdown
undo shutdown
View
Ethernet port view
Parameter
None
Description
■ Use the shutdown command to disable an Ethernet port.
■ Use the undo shutdown command to enable an Ethernet port.
By default, the Ethernet port is enabled.
Example
To enable Ethernet port Ethernet1/0/1, enter the following:
[SW7700-Ethernet1/0/1]undo shutdown
speed Syntax
For a 100 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | auto }
For a 1000 Mbps Ethernet port, the parameters for this command are as follows:
speed { 10 | 100 | 1000 | auto }
The undo form of this command is:
undo speed