Switch 7700 Command reference Guide, v2.0

Ethernet Port Configuration Commands 59
View
Ethernet port view
Parameter
10: Enter to set the port speed to 10 Mbps.
100: Enter to set the port speed to 100 Mbps.
1000: Enter to set the port speed to 1000 Mbps. (Only available on 10/100/1000
ports).
auto: Enter to set the port speed to auto-negotiation.
Description
■ Use the speed command to configure the port speed.
■ Use the undo speed command to restore the default speed. By default, the
speed is
auto.
Related command: duplex.
Example
To configure the port speed of port Ethernet1/0/1 to 10Mbps, enter the following:
[SW7700-Ethernet1/0/1]speed 10
vlan-vpn Syntax
vlan-vpn { enable | disable }
undo vlan-vpn
View
Ethernet port view
Parameters
enable: Enables port VLAN VPN.
disable: Disables port VLAN VPN.
Description
■ Use the the vlan-vpn command to enable or disable port VLAN VPN.
■ Use the the undo vlan-vpn command to restore the default status, which is
VLAN VPN disabled.
You can not enable VLAN VPN on a port if any of the following are enabled: GVRP,
GMRP, STP, 802.1x, NTDP or NDP .
Example
To enable VLAN VPN on Ethernet port 1/0/1, enter the following:
[SW7700-Ethernet1/0/1]vlan-vpn enable