Switch 7700 Command reference Guide, v2.0

60 CHAPTER 2: USING PORT COMMANDS
Ethernet Port Link
Aggregation
Commands
This section describes the commands you can use to configure Ethernet Port LInk
Aggregation on the Switch 7700.
display link-aggregation Syntax
display link-aggregation [ master_port_number ]
View
All views
Parameter
master_port_number: Enter the port number of the master port in an
aggregation port group.
Description
Use the display link-aggregation command to view information on all link
aggregations, or the link aggregation of a specified master port.
If you enter the command with a master port number, information on the specific
link aggregation group will be displayed. If you enter the command without a
master port number, information on all link aggregation groups is displayed.
Related command: link-aggregation.
Example
To display information on the aggregation group with the master port number
Ethernet1/0/1, enter the following:
<SW7700>display link-aggregation ethernet1/0/1
The information display in the following format:
Master port: Ethernet1/0/1
Other sub-ports:
Ethernet1/0/2
Mode: both
link-aggregation Syntax
link-aggregation start_port_number to end_port_number { both |
ingress }
undo link-aggregation { master_port_number | all }
View
System view
Tab le 4 The description of link aggregation
Field Description
Master port Indicates the number of the master port
Other sub-ports Indicates other member ports.
Mode Indicates the aggregation mode