Switch 7700 Command reference Guide, v2.0

VLAN Configuration Commands 69
View
VLAN interface view.
Parameter
None
Description
■ Use the shutdown command to disable the VLAN interface.
■ Use the undo shutdown command to re-enable the VLAN interface.
By default, when all Ethernet ports are in DOWN status in VLAN interface, the
VLAN interface is in DOWN status, i.e. disabled status. When one or more
Ethernet ports in VLAN interface are in UP status, the VLAN interface is UP.
This command can be used to reset the VLAN after you have changed the VLANs
settings. Alternatively, if the VLAN interface fails, use this command to shut down
and restart the interface. Shutting down or starting a VLAN interface does not
have any effect on the ports assigned to this VLAN.
Example
To shutdown and restart the interface, enter the following:
[SW7700-VLAN-interface2]shutdown
[SW7700-VLAN-interface2]undo shutdown
vlan Syntax
vlan vlan_id
undo vlan vlan_id
View
System view
Parameter
vlan_id: Enter the ID of the VLAN you want to configure, in the range 1 to
4094.
Description
■ Use the vlan command to enter the VLAN view, and use the related
configuration commands.
■ Use the undo vlan command to exit from the specified VLAN. VLAN 1 is
default VLAN and cannot be deleted.
Related commands: display vlan.
Example
To enter VLAN 3, enter the following:
[SW7700]vlan 3