Switch 7700 Command reference Guide, v2.0

GARP Configuration Commands 71
The information displays in the following format:
GARP statistics on port Ethernet1/0/1
Number Of GMRP Frames Received : 0
Number Of GVRP Frames Received : 0
Number Of GMRP Frames Transmitted : 0
Number Of GVRP Frames Transmitted : 0
Number Of Frames Discarded : 0
The above table indicates that the number of GVRP and GMRP packets received
and sent on Ethernet port 1/0/1 is 0, and that the number of discarded packets
is 0.
display garp timer Syntax
display garp timer [ interface interface_type interface_number [to
interface_type interface_number ]]
View
All views
Parameter
interface_type: Enter an interface type. This can be either Ethernet or
GigabitEthernet.
interface_number: Enter an interface number, in the format
slot-number/subslot-number/port-number. On the Switch 7700 7-slot chassis:
■ The slot number is a number in the range 1 to 6 (the Fabric slot is 0).
■ The subslot number is always set to 0.
■ The port number is a number in the range 1 to 8 (on an 8-port Gigabit
module),
1 to 24 (on a 24-port 100BASE-FX module), or 1 to 48 (on a 48-port
10/100/BASE-TX modules).
You can use the interface_name at this command. This is made up of
interface_type and interface_number parameters combined as a single
parameter, for example Ethernet0/0/1.
to interface_type interface_number: If you want to display timer statistics
on a range of ports, use this parameter to indicate the last port in the range. This
parameter is optional.
You can enter up to ten interface_type and interface_number parameters at
one display garp timer command.
Description
Use the display garp timer command to view the GARP timer statistics on a
port, a range of ports or all ports.
CAUTION: The GARP timers on all connected Layer 2 devices must have the same
timer values set. If the timer values do not match, GARP applications may not
operate successfully.