Switch 7700 Command reference Guide, v2.0

74 CHAPTER 3: USING VLAN COMMANDS
■ The port number is a number in the range 1 to 8 (on an 8-port Gigabit
module),
1 to 24 (on a 24-port 100BASE-FX module), or 1 to 48 (on a 48-port
10/100/BASE-TX modules).
You can use the interface_name at this command. This is made up of
interface_type and interface_number parameters combined as a single
parameter, for example Ethernet0/0/1.
to interface_type interface_number If you want to display timer statistics on a
range of ports, use this parameter to indicate the last port in the range. This
parameter is optional.
You can enter up to ten interface_type and interface_number parameters at
one reset garp statistics command.
Description
Use the reset garp statistics command to reset the GARP statistics
information for a port, a range of ports or all ports.
This command clears the GARP statistics information, that is the number of GVRP
and GMRP packets received or sent, and the number of discarded packets.
Related command: display garp statistics
Example
To clear GARP statistics information for all ports, enter the following:
<SW7700>reset garp statistics
GVRP Configuration
Commands
This section describes the commands you can use to configure and manage the
GARP VLAN Registration Protocol (GVRP) on your Switch 7700.
display gvrp statistics Syntax
display gvrp statistics [ interface interface_type interface_number
[to interface_type interface_number ]]
View
All views
Parameter
interface_type Enter an interface type. This can be either Ethernet or
GigabitEthernet
■ The slot number is a number in the range 0 to 6 (the Fabric slot is 0).
interface_number: Enter an interface number, in the format
slot-number/subslot-number/port-number. On the Switch 7700 7-slot
chassis:
■ The subslot number is set to 0.
■ The port number is a number in the range 1 to 8 (on an 8-port Gigabit
module),
1 to 24 (on a 24-port 100BASE-FX module), or 1 to 48 (on a 48-port
10/100/BASE-TX modules).