Switch 7700 Command reference Guide, v2.0

92 CHAPTER 4: USING NETWORK PROTOCOL COMMANDS
Parameter
vlan_id: Enter the VLAN interface number.
Description
Use the display dhcp-server interface vlan-interface command to display
the information on the DHCP Server group corresponding to a specific VLAN
interface.
Related commands: dhcp-server, debugging dhcp-relay.
Example
To view the information on the DHCP Server group corresponding to
VLAN-Interface 2, enter the following:
<SW7700>display dhcp-server interface vlan-interface 2
The information displays in the following format:
The DHCP server group of this interface is 0
The information shown above indicates that vlan-interface 2 is configured with a
DHCP Server group whose ID is 0.
IP Performance
Configuration
Commands
This section describes the commands you can use to configure and manage the IP
perfomance of your Switch 7700.
display ip statistics Syntax
display ip statistics
View
All views.
Parameter
None.
Description
Use the display ip statistics command to view statistics information on IP
packets.
Related commands: display ip interface vlan-interface, reset ip
statistics
.
Example
To display information on IP packets, enter the following:
<SW7700>display ip statistics