Switch 7700 Command reference Guide, v2.0

96 CHAPTER 4: USING NETWORK PROTOCOL COMMANDS
Description
Use the reset tcp statistics command to reset the TCP statistics information.
Related commands: display tcp statistics
Example
To reset the TCP statistics information, enter the following:
<SW7700>reset tcp statistics
tcp timer fin-timeout Syntax
tcp timer fin-timeout wait_time
undo tcp timer fin-timeout
View
System view
Parameter
wait_time: Enter the TCP fin-wait time in seconds, in the range 76 to 3600. The
default is 675 seconds.
Description
■ Use the tcp timer fin-timeout command to set the TCP fin-wait time.
■ Use the undo tcp timer fin-timeout command to restore the default TCP
fin-wait time.
When the TCP connection state changes from FIN_WAIT_1 to FIN_WAIT_2, the
fin-wait timer is enabled. If the switch does not receive a FIN packet within the
time specified using this command, the TCP connection is terminated.
Related commands: tcp timer syn-timeout, tcp window.
Example
To configure the TCP finwait timer value as 800 seconds.
[SW7700]tcp timer fin-timeout 800
tcp timer syn-timeout Syntax
tcp timer syn-timeout wait_time
undo tcp timer syn-timeout
View
System view
Parameter
wait_time: Enter the TCP syn-wait time in seconds, in the range 2 to 600. The
default is 75 seconds.