SuperStack 3 Switch 4300 Software Version 1.01 Release Notes

Known Problems with the Management Software 3
Known Problems with the Management
Software
■
Auto-MDIX mode is not available if auto-negotiation is
disabled on a port. That port will only operate in MDI
mode.
■
If a port is a member of an untagged VLAN, you might
want to change the port’s status from untagged to
tagged. If so, you must move the port to a different
VLAN that receives all untagged traffic, make the
change and then make the port a tagged member of
the original VLAN. To do this:
1
Move the port to a different VLAN that receives all
untagged traffic. To do this:
a
Enter the CLI command
bridge vlan
modify addPort
.
b
Type the VLAN ID that you want to move the
port into and press
Return
.
c
Type the port number to be moved and press
Return
.
d
Enter
untagged
for the Tag Type and press
Return
.
2
Make the port a tagged member of the original
VLAN. To do this:
a
Enter the CLI command
bridge vlan
modify addPort
.
b
Type the original VLAN ID and press
Return
.
c
Type the port number and press
Return
.
d
Enter
tagged
for the Tag Type and press
Return
.
■
IGMP Snooping cannot be disabled. The Web Interface
and the Command Line Interface appear to let you
disable IGMP, however, it will remain enabled.
■
When you power-cycle the Switch, a
Cold Start Trap
will not occur.
■
When you place a port in an Aggregated Link, the
Flow
Control
command is always enabled.
■
When a port is a member of an Aggregated Link, the
port is visible in the Bridge menus but cannot be
configured.
■
To add a port to an Aggregated Link, perform either of
the following operations.
1
Disconnect the cable from the port.
2
Add the port to the Aggregated Link.
3
Reconnect the cable to the port.
or
1
Add the appropriate ports to the Aggregated Link.
2
Power Cycle the Switch 4300 by either
disconnecting and then reconnecting the power
supply or by using the
system control reboot
command on the CLI.
■
To remove a port from an Aggregated Link, perform
either of the following operations.
1
Disconnect the cable from the port.
2
Remove the port from the Aggregated Link.
3
Reconnect the cable to the port.
DNA1710-0AAA01_rev01.fm Page 3 Monday, April 30, 2001 2:53 PM